Brother Fax-700 - Manual (Page 114)

5. m ADVANCED USES
• The destination group on your machine and the one used
by the relay unit must be identical (that is, have the same
members). Otherwise the relay unit may send the docu­
ment to a station for which the document was not intend­
ed.
• The memory in the relay unit must nut become full during
the transmission operation.
Sending a relay broadcast request
1) Set a document face down in the feeder.
2) Press the FUNCTION key. A message will prompt you to
use the cursor keys to scroll through the functions manual­
ly. Scrolling will begin automatically after two seconds.
U S E < > T O S C R O L L
E N T E R N O . & S E T K E Y
3) Press 7.
7 . R E L A Y B R O A D C A S T
P R E S S S T O P T O C A N C E L
4) Press SET. You will be prompted to enter the relay pass­
word. Use the number keys to enter this four-digit pass­
word.
R E L A Y P A S S W O R D : X X X X
E N T E R & S E T K E Y
5) Press SET and enter the number of the group to which you
will send your fax. (You must use the number keys for this.
The one-touch key registered for the group number cannot
be used.)
G R O U P N O . : I X
E N T E R & S E T K E Y
6) Press SET. Enter the number of the relay unit, then press
START.
R E L A Y B R O A D C A S T
E N T E R N O . & S T A R T
- You must use two digits (such as 01 or 02) whenever you
enter a group number.
Using Your Machine as the Reiay Unit (FAX-800M only)
Your machine can be used as a relay unit for sending broad­
cast transmissions to several other destinations. As this is an
automatic operation, simply leave your machine in the Auto
Ans. mode, and the unit will dial and send the fax to the
numbers included in the group specified at the point of ori­
gin.
5-34