Brother Fax-700 - Manual (Page 66)

4. BASIC USES
5) Press SET.
S E T U P O N E - T O U C H D I A L
S E L E C T O N E - T O U C H K E Y
6) Press the ONE-TOUCH key you want to register. Any pre­
viously registered numbers will appear on the screen to re­
quest whether you want to change the number. Press 1 to
continue.
* 0 1 : B I C U S
C H A N G E ? l . Y E S 2 . N O
7) After pressing 1 (or if no number was previously regis­
tered), the screen will prompt you to enter the fax or phone
number you want to register.
* 0 1 : 0 5 3 4 3 5 3 5 5 3
E N T E R & S E T K E Y
8) Use the number keypad to enter the fax or telephone num­
ber (which can be up to 20 digits long).
* 0 1 : 3 0 8 7 8 3 1 7 3 5
E N T E R & S E T K E Y
9) Press SET and the screen will prompt you to enter a name
for this fax or telephone number.
N A M E : B I C U S
Ë N T E R / P R E S S S E T T O E N D
10)Enter the name (which can be up to 17 characters long on
the FAX-700, or 20 characters long on the FAX-800M) as de­
scribed in the section
Entering information using the keys.
iDPress SET when you have finished and use the cursor keys
to specify FAX, TEL, F/T, or CHAIN as the type of number
you are registering.
N A M E : B R 0 T H E R
E N T E R / P R E S S S E T T O E N D
T Y P E O F N U M R F R : F A X
S E L E C T < > & S E T K E Y
12)After you have made your selection, press SET. You can
repeat the steps above to continue to register one-touch
numbers. Press
STOP if you want to exit operations at this
point.
- Chain dialing is used to link up to five programmed dial­
ing numbers.
- Selecting the number type
Choose FAX if you are registering a fax number. (This is
the initial setting.)
Choose TEL if you are registering a telephone number.
Choose F/T if you are registering a number used for both a
fax machine and telephone.
S E T U P O N E - T O U C H D I A L
S E L E C T O N E - T O U C H K E Y
4-32