Brother Fax-700 - Manual (Page 57)

4. BASIC USES
2. SENDING A FAX
There are two methods of sending a fax transmission - auto­
matic and manual
Automatic transmission
To send a document automatically, set the document face
down in the document feeder. To perform automatic trans­
mission, do not press the HOOK button or lift up the handset.
The following screen appears:
1) Dial the fax number of the destination using one-toueh,
speed dial, Telephone Index, or manual dialing. Then,
press the START key.
2) The document is read through the machine automatically.
3) On successful completion of transmission, the machine
will beep. If the transmission verification function is ON,
then you will get a report at the end of each transmission
(See page 4-18.).
- // the telephone connection was unsuccessful, and the
auto redial function was set to ON, the machine will try
to send again automatically. If auto redial was set to
OFF, the transmission must he attempted again. (See page
4-15.)
- If your transmission was not successful, the unit will
print out a Transmission Verification Report (error) auto­
matically. (See page 4-19) If the other party is busy or if
there is no response, the message NO RESPONSE OR
BUSY will appear on the LCD, and the unit will print out
a Transmission verification Report (busy) automatically.
- Whenever an automatic transmission is sent, an impor­
tant "CNG" signal is also transmitted. This signal is
essential to FAX/TEL switching and TAD operations.
F A X E N T E R N O . & S T A R T
C O P Y P R E S S C O P Y K E Y
4-23