Brother Fax-700 - Manual (Page 72)

4. \ BASIC USES
6) Press SET. Any previously registered numbers will appear
on the screen to request whether you want to change the
number. Press 1 to continue. (If no number is registered go
to step 7.)
#01: 053 435 3553
CHANGE? l.YES 2.N0
7) After pressing 1 (or if no number was previously regis­
tered), the screen will prompt you to enter the fax or phone
number you want to register.
#01
ENTER & SET KEY
8) Use the number keypad to enter the fax or telephone num­
ber (which can be up to 20 digits long).
#01:308 783 1735
ENTER & SET KEY
9) Press SET. The screen will prompt you to enter a name for
this fax or telephone number.
NAME:_
ENTER/PRESS SET TO END
10)Enter the name (which can be up to 15 characters long for
FAX-700, 20 for the FAX-800M) as described in the section
Entering information using the keys.
IDPress SET when you have finished. Then use the cursor
keys to specify FAX, TEL, F/T, or CHAIN as the type of
number you are registering. After you have made your se­
lection.
NAME:BROTHER
ENTER/PRESS SET TO END
TYPE OF NUMBER : FAX
SELECT < > & SET KEY
12)Press SET and you can repeat the steps above to continue
to register speed-dial numbers. Press STOP if you want to
exit operations at this point.
- Selecting the number type
Choose FAX if you are registering a fax number. (This is
the initial setting.)
Choose TEL if you are registering a telephone number.
Choose F/T if you are registering a number used for both a
fax machine and telephone.
Choose CHAIN if you are registering a number for chain
dialing (see page 4-39).
- To continue registering speed-dial numbers
You can continue to register speed-dial numbers until you
press STOP to exit this operation. When registering a
speed-dial number or name, pressing the CLEAR key will
delete the characters shown to the right of the cursor.
SETUP SPEED-DIAL : #
ENTER & SET KEY
4-38