Brother Fax-700 - Manual (Page 136)

I
6. ■ TROUBLESHOOTING
ERROR MESSAGES
An error message is displayed on the LCD when a malfunc­
tion occurs or when an operation has been done incorrectly
When some of the error messages described below appear on
the screen, an alarm will sound continuously for 4 seconds.
MACHINE ERRORS
If the unit detects the end of the roil of the recording paper,
this display will appear to inform you that the unit is out of
paper.
This message may also appear if the paper has not been
loaded properly.
This indicates a document paper jam inside the machine or
the feeder. Open the panel cover to remove the jammed doc­
ument. When the jam has been corrected, close the cover. If
this does not correct the error, contact Brother service and
inform them of the situation.
P A P E R R O L L E M P T Y
D O C U M E N T J A M
This indicates a recording paper jam inside the machine.
Open the recording cover to pull the jammed paper out of the
recording paper guide, as shown in the illustration below.
When the jam has been corrected, cut the edge of the record­
ing paper with a pair of scissors, and reset it properly in the
guide. Then close the cover of the machine.
R E C O R D I N G P A P E R J A M
This indicates that the cutter is not at the home position
because a recording paper jam is obstructing the movement
of the cutter inside the machine. First, unplug the machine.
Then open the cover to remove the jammed paper. (Use cau­
tion when handling the paper, as the cutter is quite sharp.)
After the paper jam has been corrected, reset the paper roll in
position, and close the cover. Finally, plug in the machine
again. The cutter will return to the home position automati­
cally.
C U T T E R J A M
6-6