EVCO c-pro mega RACK - Manual (Page 47)

C-PRO MEGA RACK & C-PRO GIGA RACK APPLICATION MANUAL
Page 47
PF64
Fan inverter
minimum
Circuit 3
Differential for fan
regulation with circuit 3
inverter
0.5 0.0 20.0 Bar IS-RF
Visible if PG01
> 2 and PG30 =
0 and
PG52 = 1
PF65
Fan inverter SP
offset.
Circuit 3 Suction setpoint offset for
circuit 3 inverter regulation
of the fan.
0.0 -20.0 20.0 Bar IS-RF
Visible if PG01
> 2 and PG30 =
0 and
PG52 = 1
PF66
Fan inverter
minimum
Circuit 3
Minimum fan value with
circuit 3 inverter
0.0 0.0 100.0 % IS-RF
Visible if PG01
> 2 and PG30 =
0 and
PG52 = 1
PF67
Fan inverter
speedup
Circuit 3
Fan speedup time with
circuit 3 inverter
2 0 999 Sec IS-RF
Visible if PG01
> 2 and PG30 =
0 and
PG52 = 1
PF68
Fan inverter time
Circuit 3
Inverter ramp. Time taken
for the inverter to go from
the minimum value to the
maximum value ( circuit 3
neutral zone reg.)
10 0 999 Sec IS-RF
Visible if PG01
> 2 and PG30 =
0 and
PG52 = 1
PF01 Fan rotation
Type of rotation used for
fan management:
0: FIFO
1: LIFO
2: FIFO + time
3: LIFO + time
FIFO FIFO (0)
LIFO
+ time
(3)
IS-F
PF02
Enable
compressor
regulation If enabled, allows selection
of fan regulation, only if at
least one compressor is on
NO NO (0) YES (1) IS-F
PF07 TOnOther
Minimum time that must
elapse before another fan
can be switched on
2 0 999 Sec IS-F
PF08 TOffOther
Minimum time that must
elapse before another fan
can be switched off
2 0 999 Sec IS-F
PF11
Fan probe error
Circuit 1
Number of fans that will be
forced if an alarm occurs on
the circuit 1 supply probe
1 0 PG41 IS-F
PF31
Fan probe error
Circuit 2
Number of fans that will be
forced if an alarm occurs on
the circuit 2 supply probe
1 0 PG45 IS-F
Visible if PG01
> 1 and
PG30 = 0
PF51
Fan probe error
Circuit 3
Number of fans that will be
forced if an alarm occurs on
the circuit 3 supply probe
1 0 PG51 IS-F
Visible if PG01
> 2 and
PG30 = 0
PF71
Enable floating
condensation
Enables floating
condensation for fan
management
NO NO (0) YES (1) IS-F