FingerTec TCMS V2 - Manual (Page 18)

18
For example, workcode 1 is for meeting clients, workcode 2 is for attending training, 3 is for conference, 4 is for
clinic visit and etc. Code Available: 1-99
If the workcodes have been set in the terminal, click Get Settings to obtain the informa-
tion or you could define the workcode in this window and click Set Settings to apply the
workcode in the terminal.
Click on the checker In Use if you wish to use the workcode in the terminal.
Save the information and Close once you are done.
Other Functions in Terminal Advanced Settings
Returning to Default Settings
A click on this button returns all the previously set settings to its default settings.
Note: Caution is recommended before you attempt to return to default settings.
Saving Information via Set Settings
Once you have completed filling up the information in the Terminal Advanced Settings
page, click Set Settings to save the information in your terminal.
Printing Settings for Reference
Click Print Settings to print the existing setting for your reference.
Updating Firmware in Terminal Advanced Settings
FingerTec always recommends its employees to have the updated firmware of the ter-
minal. However, caution needs to be exercised before attempting this function because
it could cause damage to the terminal. It is highly recommended that you consult your
reseller before you attempt this function. Alternatively, you can contact us at
support@
fingertec.com to obtain more information about Firmware Update.
Exiting Terminal Advanced Settings
Click Close when you have completed the settings of your terminal and proceed with
other terminals connected to the TCMS V2.