FingerTec TCMS V2 - Manual (Page 25)

25
Round Midpoint
Once you insert a value here, the software will calculate the value’s midpoint. For example if you set
the value at 15 min, the midpoint would be at 7 min. The clocking schedule’s IN time is 9.00am and
the midpoint is 7 min.
If the user verifi es in less than 7 minutes after the IN time, for example 9.07 a.m., the software will round
down the transaction data to be displayed as 9.00am. If the user verifi es more than 7 minutes after the
IN time, the software will round up the transaction data to be displayed as 9.15 a.m.
Round Up
OT is rounded up to the nearest minute and
is set to 15, all minutes will be rounded up as
per below:
1-15 minutes = 15
16-30 minutes = 30
31-45 minutes = 45
46-59 minutes = 1 hour
Round Down
OT is round down to the nearest minute and is
set to 15, all minutes will be rounded down as
per below:
1-15 minutes = 0
16-30 minutes = 15
31-45 minutes = 30
46-59 minutes = 45
Round Midpoint
Once you insert a value here, the software will calculate the value’s midpoint. For example if you set
the value at 30 min, the midpoint would be 15 min. The clocking schedule’s OT time is 6.00pm and the
midpoint is 15 min.
If the user verifi es in less than 15 minutes after the OT time, for example 6.15pm, the software will round
down the transaction data to be displayed as 6.00pm. If the user verifi es more than 15 minutes after the
IN time, the software will round up the transaction data to be displayed as 6.30pm.
Round up or round down the OT time to the nearest (minutes)
First rounding time range
This function is entitled for the IN time only. You can round the IN time into your pre-
ferred time. For example: any transaction between 9.01am – 9.15am will be rounded
as 9.00am.
Last rounding time range
This function is entitled for the OUT time only. You can round the OUT time into
your preferred time. For example: any transaction between 5.01pm – 5.15pm will be
rounded as 5.00pm.
Note: Specify the rules based on your company’s policy. Leave them blank if it’s not applicable to your envi-
ronment.