CIRCUTOR CVMk2 Series - Manual (Page 63)

63
CVM k2
CONFIGURA
TION
You must assign a name and the desired IP address. The IP address must be in the same
address limit than does the computer. This step will fail because they do not find the device
with the IP that was assigned and display the next screen to request the MAC address of the
card.
You must enter the MAC address of the ethernet card and click accept. The software sends the new IP
address to the expansion card analyzer
Once the card is inserted, continue with its configuration. To do so, select the MENU option from
the upper bar on the display and press SET to access the drop-down menu.
From the three options that appear on the drop-down menu (card 1, card 2 or card 3), count
from the top side of the system to select the position where the expansion card is inserted.
NOTE:
If there is no card inserted in the position selected, the message NO CARD will
appear on screen
Confirm the selection with the SET button, and continue with the card configuration.
4.7.4.3. μSD card configuration
4.7.4.4. μSD Card parameters
To view the memory card parameters, enter the MENU , select cards , and navigate to the
corresponding card to see the features.