CIRCUTOR CVMk2 Series - Manual (Page 82)

82
CVM k2
CONFIGURA
TION
To view another measurement module, press the sel (F4) button and access the list of
connected modules. The cursor will be positioned over the first line, which corresponds with
the first module configured in the list.
Use the up-down arrow buttons to move the cursor to the desired module. Press
SET to enter
the desired value.
On the screen a list will outline all measurement modules that have been configured and
entered on the screen. The list shows the following parameters.
0123456789 abcdefghij YES/NO
0123456789 : This is the serial number of the module detected by the screen.
abcdefghij : This is the name configured for this module.
yes/no : This indicates the module selected to view in the screen.
The name of the module selected is displayed on the upper right hand side of the screen. If
another module is selected, the name will change to indicate the measurement module that
corresponds with the values currently displayed at any time.
To view the parameters of another module in the list, navigate to the module using the arrow
buttons. When the cursor is over the desired module, select it by pressing
sel (F4) in order to
change the menu option to yes and then confirm with ok .
To change the module that is viewed on the display, choose system from the menu . In system ,
access the modules drop down menu and select the list option. Then, confirm with the set
button.