Zilog Z86193 - Manual (Page 88)

Z8
®
CPU
User Manual
UM001604-0108 Counters and Timers
81
(T
IN
) using P31. Port 3 line P36 can serve as a timer output (T
OUT
) through which T0, T1,
or the internal clock can be output. The timer output toggles at the end-of-count.
The counter/timer, prescaler, and associated mode registers are mapped into the register
file as displayed in
Figure 69 . This allows the software to treat the counter/timers as gen-
eral-purpose registers, and eliminates the requirement for special instructions.
Prescalers and Counter/Timers
The prescalers,
PRE0 (F5h)
and
PRE1 (F3h)
, each consists of an 8-bit register and a 6-
bit down-counter as displayed in Figure 68 on page 80. The prescaler registers are write-
only registers. Reading the prescalers returns the value
FFh
. Figure 70 on page 82 and
Figure 71 on page 82 displays the prescaler registers.
The six most significant bits (D2–D7) of PRE0 or PRE1 hold the prescalers count modulo,
a value from 1 to 64 decimal. The prescaler registers also contain control bits that specify
T0 and T1 counting modes. These bits also indicate whether the clock source for T
1
is
internal or external. These control bits will be discussed in detail throughout this chapter.
The counter/timer registers, T0 (
F4h
) and T1 (
F2h
), each consists of an 8-bit down-
counter, a write-only register that holds the initial count value, and a read-only register
that holds the current count value (see
Figure 68 on page 80). The initial value can range
from 1 to 256 decimal (
01h
,
02h
,..,
00h
). Figure 72 on page 83 displays the counter/timer
registers.
Figure 69. Counter/Timer Register Map
HEX Identifiers
T0 Prescaler
F7
Timer/Counter0
Port 3 Mode
T1 Prescaler
Time/Counter1
Timer Mode
F5
F4
F3
F2
F1
DEC
247
245
244
243
242
241