Fluke Biomedical HHC3 - Manual (Page 11)

1-1
Chapter 1
Introduction and Specifications
Introduction
The HHC3 Hand-Held Controller (hereafter called the “Controller”) facilitates
the direct selection of parameters for the Fluke Biomedical medSim 300B,
MPS450, and Marq III simulators. The Controller uses telephone receiver
cable for connection to a simulator. The Controller provides for single-key
commands, dual-key commands, factory-defined sequences, or easy
programming of user-defined sequences. It displays the current waveform
selection and the user prompt on the alphanumeric display.
Safety
WX Warning. Read before using the Controller.
To avoid personal injury, follow these guidelines:
• Do not use in any manner not specified in the Users
Manual. Otherwise, the protection provided by this product
may be impaired.
• Always press power off on the Controller and unplug the
Battery Eliminator before cleaning the outer surface.
• Inspect the product. If the Controller appears damaged or
appears to operate in a manner not specified in the
manual, DO NOT CONTINUE USE. Return for service.
• Avoid spilling liquids on the Controller; fluid seepage into
internal components creates corrosion and a potential
shock hazard. Do not operate the instrument if internal
components are exposed to fluid.
Do not open this product. There are no user replaceable
parts.