Adding commands – Fluke Biomedical HHC3 User Manual
Page 46
Advertising
HHC3
Users Manual
3-20
After two seconds, the display returns to:
14. If you press T at SKIP ACTION AFTER LAST CMD, the display
changes to:
After two seconds, the display returns to:
Adding Commands
If you pressed T at ADD COMMAND, the Controller adds a new command
at the end of all the commands in the sequence. You will be defining the new
command and the corresponding delay. The display shows:
1. Press the first digit (from B to J) of the chosen two-digit waveform.
2. Press the second digit (from B to P) of the chosen two-digit
waveform. If the two-digit waveform number just entered is an immediate
Advertising