Fluke Biomedical HHC3 - Manual (Page 24)

HHC3
Users Manual
2-10
Immediate Commands
The Controller will act upon single-key and dual-key commands either
immediately or after you complete at least one additional step.
The Controller sends many commands as soon as you press a single key or
complete a dual-key sequence. These are immediate commands: no other
selection is necessary. The Controller display identifies each immediate
command.
All single-digit commands except B are immediate. For a dual-key
immediate command example, press Q B K, which yields the
following display:
The Controller sends this command to the simulator without further action.
Stepped Commands
Pressing a single-key or selecting the second key in a dual-key sequence can
require a secondary selection. These are stepped commands: additional
selections may be required. The display identifies such a command with up and
down arrow symbols. You press R or S to make the stepped command
selection. For example, pressing Q C G yields the following display:
Pressing R at this point accesses the next selection for this stepped
command, as follows:
With the required selection displayed, press T to send the command to the
simulator.