Formax ColorMaxLP Operator Manual - Manual (Page 12)

12
Setting Up the Printer
Formax
Selecting the Security Level
By default, the printer powers up in security Level 0 (operator), which does not allow changes to
some printer settings. For the initial Printer Setup, it is recommended that you change the
Security Level to 2 (Administrator) before changing those settings.
NOTE: During initial Setup, Security may already be preset to Level 2. The display will
immediately go to the Language setting if it is.
1. On the control panel, select (Config) > Setup > Security > Level 2.
2. Enter the 3-digit password (default is 123).
3. Press to return to the main menu.
Table 3 Security Restrictions
Security Level Restricted Settings
Operator (Level 0) Language, Reset, LCD Contrast, LCD Brightness,
Date/Time, Unit, Service Station, Sensor, Ext Signal
Print, Adjust Offset, DHCP Setting, IP Settings
Supervisor (Level 1) Reset, Day/Time, DHCP Setting, IP Settings
Administrator (Level 2) No restrictions
 
Printer Online
CONFIGURATION
1. SETUP
SETUP
2. SECURITY
SECURITY
2. Level 2
(Config)
(Select)
ENTER PASSWORD
Enter the first password digit using
the + or - button, then press
Select . Repeat for next two digits.
Authenticated message will
appear with the right password
Items in bold indicate no access to an entire menu; others are specific functions.