Formax ColorMaxLP Operator Manual - Manual (Page 60)

60
Printer Maintenance
Formax
Replacing the Aerosol Fan Filter
As a general guideline, replace the aerosol fan filter every six months.
1. Turn off power to the printer. See Printing Borderless (Full-Bleed) Labels on page 32.
2. Open the clamshell to its highest position.
3. Insert the tip of a flat-blade screwdriver into the slot at the corner of the aerosol fan
assembly, and pry the cover off.
4. Remove the filter ( Figure 8 ) and replace it with a new one.
5. Snap the cover back into place on the aerosol fan assembly.
6. Close the clamshell and top cover. Turn the printer back on.
Figure 8 Fan assembly
Tools • Nitrile powder-free gloves
• Flat-headed screwdriver
filter cover aerosol fan assembly
slot