Formax ColorMaxLP Operator Manual - Manual (Page 58)

58
Printer Maintenance
Formax
7. Pull the service station forward until you can disconnect the flex cable to the wiper
motor. Loosen the clip on the connector ( Figure 6 ) to release the flex cable.
Ensure that the flex cable does not come into contact with any metallic
surface. If it is touching metal and the printer is accidentally turned on, it will
short the controller circuit and damage the printer.
Take care when handling the service station. Ink may spill when you tilt the service
station.
Never turn on the Printer with the Service Station disconnected!!!
NOTE: Dispose of the old service station according to local regulations.
Installation
8. Insert the flex cable into the connector on the new service station and push in the
clip to secure it.
Figure 6 Flex cable to connector on service station
flex cable
clip
clip flex cable