Formax ColorMaxLP Operator Manual - Manual (Page 78)

78
Appendix
Formax
Config Options on the Control Panel
On the control panel, press (Config) to access the following menus and options.
Menu items in Bold text require the Control Panel Security Level setting of 1 or 2
Menu items in Bold Italic text require the Control Panel Security Level setting of 2
* - These settings can only be viewed at Security Level 0. Security must be set to Level 1
or 2 to make any changes
** - These settings can only be viewed at Security Levels 0 and 1. Security must be set
to Level 2 to make any changes
1. Setup
1. Language
2. Reset Settings
3. List Setup
4. Security
1. Level 0
2. Level 1
3. Level 2
5. LCD Contrast
6. LCD Brightness
7. Date/Time**
8. Unit
9. Label
1. Continuous
2. Gap
3. Black Mark
10. Page Cutting
1. Sheets per Cut
2. Print & Present
3. Roll-Roll, leave 1st
blank
4. Roll-Roll, print first
label
5. Roll-Roll, multiple job
2. Maintenance
1. Print Test Page
1. Barcodes
2. PQ Plot
3. Printhead
1. Clean
1. Normal
2. Extended
3. Extreme
2. Replace
4. Service Station
1. Cap Printhead
2. Eject
5. Sensor
1. Transmissive
2. Reflective
3. Level
6.Ext Signal Print
1. By I/O
1. Yes
2. No
7. Adjust Offset*
1. Top of Form
2. Bottom of Form
3. Left Edge
4. Cutter Offset
8. Network
1. List
2. DHCP Settings
1.Automatic
2. Manual
3. IP Settings**
1.Static IP
2. Subnet Mask
3. Default Gateway
4. Wins Server