GAI-Tronics ICP9000 Navigator Series Console Installation and Service Manual - Manual (Page 38)

Navigator Configuration ICP9000 Navigator Installation and Service Manual
12/10 34
Tool Options
The Tool Options allow the user to configure which buttons are available in the Navigator tool bar for
each individual operator. The factory default setting displays all available buttons.
Channel Selection
The Channel Selection section determines which channels are displayed in the main window for each
individual operator.
Control
The Control portion has four different modes of operation that determine what action the display takes
after a button press.
1. Display Always On - the operator will be unable to close the Control form.
2. Push On/Off - using the Control tool options button, the operator has the ability to display the Control
form and close the form.
3. Auto Extinguish - the Control form is closed five seconds after a control button is pressed.
4. Inactivity On/Off - Control form is automatically closed if a control button has not been selected
within a pre-programmed amount of time set by the timeout.