GAI-Tronics ICP9000 Navigator Series Console Installation and Service Manual - Manual (Page 53)

49 12/10
Features and Options
The ICP9000 Navigator contains several software and hardware enabled options. Each software option
can be enabled or disabled using the CARD Suite Software so that the feature is not present in the console
during use. Refer to the CARD Suite software on-line help for more information.
Hardware options are automatically enabled when the hardware is installed in the MCU. However, the
option may have to be enabled and configured using the CARD Suite Software prior to use. Refer to the
CARD Suite software on-line help for more information.
DTMF Decode
The DTMF decode feature adds automatic number identification (ANI) capability for systems using
DTMF (dual tone multi-frequency) signaling. DTMF Decode must be enabled and programmed for your
system using the CARD Suite Software. For details refer to the online help in the CARD Suite Software
application.
16-Frequency Control
This standard feature allows up to 16 frequencies with individual aliases to be programmed for each
channel of the ICP9000 Navigator. By default, the console is configured with one active frequency. To
enable more frequencies, the CARD Suite Software must be used.
Using the CARD Suite Software, each channel can be configured to use 1 to 16 frequencies per channel.
If less than four frequencies are enabled for a channel, the F1 – F4 keys function as individual frequency
select buttons on that channel. If, however, five or more frequencies are enabled for a channel, the F1 -
F4 keys assume the function of SELECT, UP, HOME and DOWN for that channel. Refer to the ICP9000
Navigator Series Console Operator’s Manual, available in the XAC2000A Navigator Software, for
complete user instructions.
Paging Encode
The paging encode feature adds support for DTMF, 2-Tone sequential, Plectron, 5/6 Tone, 1500, 2805
and immediate DTMF paging operation. Each paging type and the parameters for each must be
configured using the CARD Suite Software. Refer to the Paging section of this manual, and the ICP9000
Navigator Series Console Operator’s Manual (available in the XAC2000A Navigator Software) for
paging encode, and the on-line help in the CARD Suite Software for details of configuration and
operation.