GAI-Tronics MRTI 2000 (No. PL1877A) Microprocessor Radio Telephone Interconnect Installation & Service Manual User Manual
GAI-Tronics Communication
Advertising
Table of contents
Document Outline
- Pub. 43004-019C
- Confidentiality Notice
- Warranty
- Table of Contents
- Foreword
- Description
- Installation
- FCC Interference Warnings
- Equipment Required
- Cable Installation Safety Considerations
- Telephone Line Lightning and Over-voltage Protection
- Rack-Mount Installation
- Installation Considerations
- Electrical Interface
- Power Supply
- P1 Radio Connector
- Internal Diagnostics
- Test 1 – TX Softpot Adjustment
- Test 2 – DTMF Decode Thresholds
- Test 3 – Mobile-to-Phone Audio Path
- Test 4 – Mobile-to-Phone Path 2
- Test 5 – Mobile-to-Phone Audio Path
- Test 6 – Non-accessed Patch Functions
- Test 7 – Active Line Swap
- Test 8 – Network Tone Decoding
- Test 9 – HC11 DSP Communications
- Test 10 – HC11 DSP Communications
- Test 11 – TX Audio Port
- Test 12 – RS-232 Diagnostic
- Test 13 – DTMF Decode on Un-accessed Phone Line
- Level Setting
- PC Programming
- General Description
- IAPS Programming
- Input/Output
- Installation
- Basic Operation
- Access/Release Settings
- Access/Release – Mobile Initiated – Mobile Access Release
- Access Command
- Normal Release Command
- Mobile Access to Busy Phone Line
- Require Multi-Digit Prefix
- Require Multi-Digit Release after Multi-Digit Access
- Multi-Digit Release Codes - Prefix/Suffix
- Bypass Multi-Digit Access Command
- Wildcard Access/Release Code
- Answer via Carrier Burst Detection (“Triple Key”)
- Disconnection on Phone Line Current Reversal, Mobile Origin
- Number of Busy Cycles Detected Before Disconnect
- Access/Release – Mobile Initiated – Mobile Access Release - Security Code Overrides
- Mobile Origination
- Reset Overall Access Timer
- Accessing Busy Phone Line
- Manual Dialing Restriction
- Redialing Restriction
- Auto-dial Restriction
- Override Restriction Starting with 0
- Override Restriction Starting with 1
- Override Restriction Starting with 9
- Override Restriction of Length of Numbers
- Toll Restrict Prefixes 1- 8
- Access/Release – Mobile Initiated - Multi-Digit Prefixes
- Access/Release – Mobile Initiated - Multi-Digit Release Codes
- Access/Release – Telephone Initiated - Direct Access
- Telephone Line Direct Access - Lines 1 & 2
- Telephone Line Access Prefix
- Require * from Telephone Line User for Direct Access - Lines 1 and 2
- Attendant Direct Access
- Attendant Access Prefix
- Require * from Attendant for Direct Access
- Direct Access Timer
- Revert to Overall Timer on Detection of Carrier
- CTCSS Strip Output During Direct Access Time
- Emergency Call Direct Access
- Mobile Ring Signaling
- Access/Release – Telephone Initiated - Misc. Access/Release
- Access/Release – Global Access/Release
- Access/Release – Mobile Initiated – Mobile Access Release
- Signaling
- Signaling – Telephone Line Dialing – Dialing Method
- Signaling – Telephone Line Dialing -Autodial/Redial
- Signaling – Telephone Line Dialing – Auto-dial Numbers
- Signaling – Telephone Line Dialing – Toll Restriction
- Signaling – Telephone Line Signaling Toll Restriction Prefixes
- Signaling – Mobile Signaling – Ring Signaling
- Station Identifier
- Paging
- Telephone Line
- Attendant Paging
- Mobile Paging
- General Paging
- Paging Format - DTMF Paging Parameters
- Paging Format – 1500 Paging Parameters
- Paging Format – 2805 Paging Parameters
- Paging Format Plectron Paging Parameters
- Paging Format – 2-Tone Paging Parameters
- Paging Format – 5-Tone Paging Parameters
- Paging Format – Multi-Mode Paging Table
- Service Adjust
- Service Adjust – Service Diagnostics
- Service Adjust – Manual Off hook - Telephone Line Off hook Threshold Voltage
- Entering Programmed Parameters
- Mobile Programming of Auto-Dial Numbers
- Wildcard Access/Release
- Programming Wildcard Access/Release
- Wildcard Access/Release with Paging
- Paging without Direct Channel Access
- Paging with Direct Channel Access
- Programming the Wildcard Code for use with Paging
- Miscellaneous Information about Wildcard Access/Release Feature
- Multi-Digit Access/Release
- Operator Instructions
- Mobile Originated Calls
- Landline Originated Calls
- Multi-Digit Access/Release
- Multi-Digit Access
- Bypassing Restrictions via Multi-digit Access
- Security Code (Privileged User Override Code)
- Installation of the Multi-Digit Access Feature
- Configuring the Security Code to Bypass Restrictions
- Multi-Digit Release
- Linking Multi-Digit Release to Multi-Digit Access
- Installation
- Wildcard Access/Release Installation
- Wildcard Access/Release with Selective Signaling
- Selective Signaling without Direct Channel Access
- Selective Signaling with Direct Channel Access
- Programming the Wildcard Template for Use with Selective Signaling
- Miscellaneous Information Regarding Wildcard Access/Release Feature
- Parameter Modification Procedure
- Terminal Programming Feature
- DTMF Programming Feature
- Mobile Programming of Auto-dial Numbers
- Installation Parameters
- Mobile Access Methods
- Manual Release Methods
- Automatic Release Methods
- General Call Characteristics
- Selectable Features
- Parameter/Function Reference Table
- Features
- Paging
- PL1877A – Radio Installation
- Theory of Operation
- Main Circuit Board
- MDP Circuit Board
- Definitions and Acronyms