Gasboy TopKAT PLUS - Manual (Page 64)

Printer Setting Printing Parameters
Page 4-8 MDE-5013C TopKAT™ PLUS Installation Manual · February 2015
Figure 4-9: Printer Module - Example Jumpers Configuration
1st Jumper
short =

71 Hex 2nd Jumper
short =

72 Hex
1st and 2nd
Jumpers
short =

73 Hex
3rd Jumper
short =

74 Hex
Parameters for Printing
The printer features two printing modes, as determined by the controller:
• Print only when the door is lifted - Paper save mode
• Print always
Cutter
The paper cutter may be set to one of the following three modes, as determined by the
controller:
• No Cut
• Full Cut
• Partial Cut
Printing Status Report
The G2 printer enables producing a printer status report. To produce a printer status report,
proceed as follows:
1 Turn off the printer.
2 Open the printer’s service door.
3 Turn on power to the printer.
4 The G2 printer prints a status report.