LSC Lighting maXim MP - Manual (Page 21)

maXim MP L(P) XL(P) XXL(P) Front Panel Tour
Operator Manual V3
LSC Lighting Systems (Aust) Pty. Ltd. Page 15
4.28 ADD BUTTON
Used to:
• Insert steps in a stack or chase when editing.
• Add a 1 to 1 patch
• Insert spaces in names
4.29 FUNCTION BUTTON
• When pressed during normal operations, it
causes the display to momentarily show the
current time “IN” or “OUT” settings of the time
faders, whilst it is held down. Subsequent
presses will toggle between the two time
settings as indicated by the “in” or “out” LEDs
above it.
• When editing, pressing [function] steps
through the various parameters that can be
changed as indicated on the LEDs above the
function button.
• After pressing [select], [f/a], pressing
[function] steps through the various
parameters that can be changed on the
selected playback.
• It accesses the secondary functions such as
reset, (USB) disk or patch etc as indicated
below
the yellow and red bank [f/a] buttons.
To perform secondary functions;
HOLD
[function] tap [f/a] (secondary function
as printed below red and yellow bank “f/a”
buttons).
4.30 EDIT WHEEL
Continuously rotatable in either direction and can
be used to:
• Set fade and link times plus chase rate and
crossfade when recording or editing.
• Adjust the level of channels when editing.
• Adjust Sound To Light parameters.
• Select DMX address numbers when patching.
• Select characters for names.
• Scroll the V1 or V2 video displays.
• Adjust selected parameters on the PatPad.
4.31 EDIT WHEEL INDICATOR
Lights when the EDIT Wheel is active.
4.32 > (YES) BUTTON
• Runs a selected or edited chase in the
FORWARD direction.
• Steps a stack forward when editing.
• Increments through the DMX address numbers
when patching.
• Answers “YES” to a request from the maXim.
• Select the next parameter on the PatPad.
4.33 < (NO) BUTTON
• Runs a selected or edited chase in the
REVERSE direction.
• Steps a stack backwards when editing.
• Decrements through the DMX address
numbers when patching.
• Answers “NO” to a request from the maXim.
• Select the previous parameter on the PatPad.
4.34 STEP STOP (OK) BUTTON
• Used to STOP a selected or edited chase or
STEP a stopped chase.
• Answers “ok” to a request from the maXim.