LSC Lighting maXim MP - Manual (Page 70)

STL and SyncoBEAT maXim MP L(P) XL(P) XXL(P)
Operator Manual V3
Page 64 LSC Lighting Systems (Aust) Pty. Ltd
on MIDI channel 1, it will step the stack to the
next step.
Stepping a chase. If the maXim has a chase on
a red 9 master and the chase is set to “single
step” then if the maXim receives the MIDI “note
56 On” then “note 56 OFF” message on MIDI
channel 3, it will step the chase to the next step.
Complex and intricate chases with varying rates
may easily be created by recording the
sequence of notes together with the timing and
duration of each note on a MIDI sequencer.
20.6 CONTROLLING A MIDI DEVICE FROM
THE MAXIM
The maXim can send MIDI commands to a MIDI
device allowing it to play sounds or trigger other
MIDI controlled events when certain maXim
buttons are pressed.
When a maXim button is pressed, a MIDI note
ON is transmitted for the MIDI note and channel
to which the button is mapped (see table below).
When a maXim button is released, a MIDI note
OFF is transmitted for the MIDI note and
channel to which the button is mapped.
When the EDIT wheel is rotated, a “Pitch
Bender” message is transmitted on MIDI
channel 1.
• Clockwise EDIT wheel movements = Pitch
UP message
• Anticlockwise EDIT wheel movements =
Pitch DOWN message.