LSC Lighting maXim MP - Manual (Page 75)

maXim MP L(P) XL(P) XXL(P) Video
Operator Manual V3
LSC Lighting Systems (Aust) Pty. Ltd. Page 69
22.4.4.1 PAD VIEW
Video 4 (Pad View) shows a list of all Fixtures loaded on the PaTPad and shows exactly which
parameters are included in your PaTPad operations because they flash.
• The Fixture numbers (Fx) are listed on the
left of the screen.
• The 24 parameter matrix buttons are
numbered across the top.
• The Fixture that is currently selected on
the PaTPad is indicated by a row of : : : :
symbols.
In the example above it is Fixture 4.
• Fixtures that have intensity on the output
have a white name. If they have no
intensity they have a cyan name.
• Fixtures that are Hi-lighted have a grey
background.
• Fixtures that are NOT Hi-lighted have a
black background
• The column of numbers on the right
shows the order in which the fixtures were
loaded onto the PaTPaD. This order will
be used when applying Fans. In this
example, it is 1,3,4,5, 6 but it
could be any order that you select. (See
the “FANS” section for details).
Parameters can be represented by the following
symbols;
-
The parameter exists.
F A filter has been applied to the parameter.
a The parameter has been altered by the
PaTPaD .
E The parameter is linked to a palEtte (not
shown above).
P The parameter is linked to a Preset (not
shown above).
The symbols are also colour coded.
RED = Colour parameter.
BLUE = Beam parameter.
GREEN= Focus parameter.
Any Parameters that are included in your
operations (as set by hi-lights and filters) will flash.
22.4.4.2 PATPAD MIMIC WINDOW
PaTPad Mimic shows the currently selected Fixture and gives an expanded view of the [PM] (Parameter)
buttons on the PaTPad. Each displayer on the PaTPad can control up to 4 parameters as selected by the
4 [PM] buttons beside it.
To see the name of each available parameter on a PaTPad displayer you have to press the appropriate
[PM] button. PaTPad Mimic is laid out in the same geographical format as the [PM] buttons so you can
always see the names of every available parameter for the selected fixture. It therefore makes parameter
selection quick and easy. The parameter(s) that are currently selected on the PaTPad are indicated by a
red background. Below each parameter, its times are shown. If the default times are being used, ** is
shown. The current default times for colour, beam and focus are displayed at the bottom of the PaTPad
Mimic window.