Itip reports, Daily – Wavetronix Command DataView (CMD-DV) - User Guide User Manual
Page 94
APPENDIX 93
ITIP Reports
All ITIP (Intelligent Transportation Infrastructure Program) reports operate on routes.
This means that when you select stations for the report, only the ones that are part of a
route are included. Likewise, if you select only stations that are not part of a route, the ITIP
reports will fail.
ITIP reports are based on the paper “The Keys to Estimating Mobility in Urban Areas:
Applying Definitions and Measures That Everyone Understands” from the Urban Trans-
portation Performance Measure Study by Texas Transportation Institute, The Texas A&M
University System.
There are two nodes available under ITIP: Daily and Monthly.
Daily
The ITIP > Daily node contains five report options:
˽
Daily Travel Time Report – This report shows the variation in trip time along a route
for a day. In this example, the travel time for the route is consistent for most of the day.
However, around the morning commute the trip time jumps from about 8.5 minutes to
12.5 minutes. This report is composed of all the days selected for the report.
Figure A.10 – Daily Travel Time Report