Grass Valley NV9000-SE v.5.0 - Manual (Page 436)

418
Tielines
‘Add Tieline Group’ Page
• Cancel
The buttons are grayed out (disabled) until they become applicable. For instance, you cannot
use the ‘Previous’ button (to go to a previous page) until you have used the ‘Next’ button to go
to one of the next pages.
‘Previous’ Button
Click the ‘Previous’ button if you want to go to the previous page in the group definition
sequence.
‘Next’ Button
Click ‘Next’ to go to the tieline group configuration page. In this page, you specify the tielines
that will belong to the group.
‘Finish’ Button
Click ‘Finish’ to accept the tieline thus far defined in the ‘Add Tieline Group’ page.
The tieline group definition, as specified in the ‘Add Tieline Group ’ page is incomplete. You must
later go to the
Tieline Group Configuration Page to edit the group.
This button allows you to create a number of tieline group definitions rapidly and complete
them later.
After you click ‘Finish’, the ‘Add Tieline Group’ page remains and is re-initialized for additional
entries.
‘Cancel’ Button
Click ‘Cancel’ if you want to terminate the tieline group definition you started.
When you click ‘Cancel’, the ‘Add Tieline Group’ page re-initializes for another entry.
Basic Information
There are 2 fields in the basic information section:
These are the basic information fields:
• Tieline Group Name
Enter a name for the tieline group in the ‘Tieline Group Name’ field. Group names are usually
known only to the configurer. Panel operators do not use them.
• Tieline Group Description
Enter any description that is useful to your configuration.