Grass Valley NV9000-SE v.5.0 - Manual (Page 70)

52
Routers
‘Router Controls’ table
Router List
This section lists the routers and, for each router, presents the following:
• The router’s name
• The control point description.
• The communication protocol.
• Communication parameters.
• The control card to which the control point applies. (NVISION series routers usually have two
control cards designated “primary” and “secondary” in NV9000-SE Utilities.)
The numbers at the left of the rows of the list are database IDs. NV9000-SE Utilities shows the list
in order of database ID by default. (You can change the ordering by clicking a column header.)
See Modifying the Table Data on page 53.
Buttons
The buttons are the same as in some other router pages:
• Add
Click ‘Add’ to add a router to the table. NV9000-SE Utilities creates a new row at the bottom
of the router list in which you can enter a name for the router and choose a host.
The ID is generated by NV9000-SE Utilities.
Although we do not recommend it, you can have duplicate router names because it is the
database ID that distinguishes one router from another.
• Delete
Select one or more rows in the routers table and click ‘Delete’ to remove those routers from
the table.
NV9000-SE Utilities deletes the router entries immediately without any dialog.
• Edit
Select one or more rows in the routers table and click ‘Edit’ to open a router details page for
each of the selected routers.
See Router Details Page on page 45 for details.
• Save
Click ‘Save’ to commit (make permanent) the changes you have made in the page.
• Revert to Saved
Click ‘Revert to Saved’ to restore the saved version of the router definition, discarding any
changes you have made (since the last save).
• ‘Save & Close’
Click ‘Save & Close’ to commit the changes you have made in the page and then close the
page.