Precision Digital PD6080 - Manual (Page 16)

PD6080/PD6081 Super Snooper Modbus Scanner Instruction Manual
16
SAFETY INFORMATION
!
CAUTION: Read complete instructions prior to
installation and operation of the scanner.
WARNING: Risk of electric shock or
personal injury.
INSTALLATION
There is no need to remove the scanner from its case to complete the installation, wiring, and setup
of the scanner.
Unpacking
Remove the scanner from box. Inspect the packaging and contents for damage. Report damages, if
any, to the carrier. If any part is missing or the scanner malfunctions, please contact your supplier or
the factory for assistance.
Panel Mounting
• Prepare a standard 1/8 DIN panel cutout – 3.622" x 1.772" (92 mm x 45 mm). Refer to Figure 1 for
more details.
• Clearance: allow at least 6" (152 mm) behind the panel for wiring.
• Panel thickness: 0.04" - 0.25" (1.0 mm - 6.4 mm).
Recommended minimum panel thickness to maintain Type 4X rating: 0.06" (1.5 mm) steel panel,
0.16" (4.1 mm) plastic panel.
• Remove the two mounting brackets provided with the scanner (back-off the two screws so that there is
¼" (6.4 mm) or less through the bracket. Slide the bracket toward the front of the case and remove).
• Insert scanner into the panel cutout.
• Install mounting brackets and tighten the screws against the panel. To achieve a proper seal, tighten
the mounting bracket screws evenly until scanner is snug to the panel along its short side. DO NOT
OVER TIGHTEN, as the rear of the panel may become damaged.
Panel
Gasket
Mounting
Bracket
Mounting
Screw
Removable
Connectors
Figure 1. 1/8 DIN Panel Cutout Dimensions & Panel Mounting Details
Warning!
Hazardous voltages exist within enclosure.
Installation and service should be performed only by trained service
personnel.
3.622" (92 mm)
1.772"
(45mm)
Panel Cutout
to DIN 43700
Square Corners to 0.060"
(1.5mm) Max Radius
A
B
Tolerances:
A: +0.032 (+0.8mm)
-0.000 (-0.0mm)
B: +0.024 (+0.6mm)
-0.000 (-0.0mm)