Avago Technologies LSI53C895A - Manual (Page 122)

4-14 Registers
controller(s) the device’s interrupt pin is connected to.
Values in this register are specified by system
architecture.
Register: 0x3D
Interrupt Pin
Read Only
IP Interrupt Pin [7:0]
This register indicates which interrupt pin the device
uses. Its value is set to 0x01 for the INTA/ signal.
Register: 0x3E
Min_Gnt
Read Only
MG MIN_GNT [7:0]
This register is used to specify the desired settings for
latency timer values. Min_Gnt is used to specify how long
a burst period the device needs. The value specified in
this register is in units of 0.25 microseconds. The
LSI53C895A sets this register to 0x11.
7 0
IP
0 0 0 0 0 0 0 1
7 0
MG
0 0 0 1 0 0 0 1