Command line interface, 1 accessing the cli, Logon to the console – PLANET WGSW-48000 User Manual
Page 164
User’s Manual of WGSW-48000
164
5. COMMAND LINE INTERFACE
5.1 Accessing the CLI
When accessing the management interface for the switch over a direct connection to the server’s console port, or via a Telnet
connection, the switch can be managed by entering command keywords and parameters at the prompt. Using the switch's
command-line interface (CLI) is very similar to entering commands on a UNIX system.
This chapter describes how to use the Command Line Interface (CLI).
Logon to the Console
Once the terminal has connected to the device, power on the WGSW Managed Switch, the terminal will display that it is running
testing procedures.
Then, the following message asks the login password. The factory default password as following and the login screen in
Figure
5-1
appears.
User name: admin
Password: admin
Figure 5-1 WGSW Managed Switch Console Login screen
To have access to the full suite of commands, the operator must enter the Privileged Mode. Enter “enable” to into the Privileged
Mode and it requires password authentication. From Privileged Mode, the operator can issue any Exec command to enter the