PLANET WGSW-48000 User Manual
Page 166
User’s Manual of WGSW-48000
166
Configure IP address
3. On
“Switch# ” prompt, type “configuration” to enter into global configuration mode.
4. On
“Switch(Config)# ” prompt, enter the following command and press <Enter>. As show in Figure 5-2.
Switch(Config)# network parms 192.168.1.100 255.255.255.0 192.168.1.1
The previous command would apply the follow settings for the Managed Switch.
IP: 192.168.1.100
Subnet Mask: 255.255.255.0
Gateway: 192.168.1.1
Figure 5-3 Set IP address screen
5.
Repeat Step 1 to check if the IP address is changed.
6. On
“Switch# ” prompt, type “Save” to save the current configuration.
If the IP is successfully configured, the Managed Switch will apply the new IP address setting immediately. You can access the
Web interface of WGSW Managed Switch through the new IP address.
If you do not familiar with console command or the related parameter, enter “?” anytime in console to
get the help description.