Switching the connection to a smart device – Nikon COOLPIX P950 Digital Camera User Manual
Page 265
265
ML-L7 Remote Control
5
Select [Connection to remote], and press the button.
•
Pairing is enabled and the camera waits for the connection to be established.
•
If you cannot select [
Connection to remote
], set the following in the network
menu.
-
[
Airplane mode
]: [
Off
]
-
[
Bluetooth
] [
Connection
] [
Enable
]
6
Press and hold (for at least 3 seconds) the power button on the
remote control.
•
Pairing starts for the camera and remote control. During the process, the status lamp
on the remote control flashes about every 0.5 seconds.
•
When pairing is complete, a connection is established between the camera and the
remote control. When you enter shooting mode, is displayed on the shooting
screen.
•
If a pairing failure message is displayed, perform the procedure again from step 5.
Switching the connection to a smart device
• In the Network menu of the camera [
], switch
the connection from [
Remote control
] to [
Smart device
].
• When the SnapBridge app is launched on your smart device, and a connection is
reestablished between the camera and smart device, on the shooting screen
flashes and then turns on again (if a smart device is paired).
• For connections or use of the SnapBridge app, see the online help of the
SnapBr