HP 8360 - Manual (Page 272)

Select Rear
Function Group POWER and FREQUENCY
Menu Map 2 and 5
Description This command causes the synthesizer to examine only the rear
panel source module interface connector to determine the type
of source module (if any) connected. The instrument frequency
limits and multiplier are altered according to the source module
connected. However, the leveling point is not changed. See
Leveling Point Module to set the synthesizer to level at the
output of the source module.
An asterisk next to the key label indicates this feature is active.
Programming Codes
SYSTem:MMHead:SELect
SYSTem:MMHead:SELect?
Analyzer: NONE
See Also Module Menu
Monitor Menu
Function Group (MOD)
Menu Map
Description This (Option 002 only) accesses the menu which allows you
to output internally-generated AM and FM waveforms to the rear
panel AM/FM OUTPUT connector. It also accesses the
which allow you to display the AM depth and FM deviation of the
modulation waveforms.
On/Off AM Outputs the AM waveform to the AM/FM
OUTPUT connector.
On/Off FM Outputs the FM waveform to the AM/FM
OUTPUT connector.
Meter On/Off AM Displays the AM depth of the modulating
signal.
Operating and Programming Reference HP 8360
User’s Handbook