HP 8360 - Manual (Page 340)

l ion :
Queries the status of any modulation. If any of the modulation states
are on, then it returns a 1, otherwise it returns a 0.
Power Subsystem Any place where is accepted as a suffix, any level suffix is
accepted also. In the absence of a suffix, the units are assumed to be
as set by the UNIT :POW command.
l POWer:ALC:BANDwidthl:BWIDth
l POWer:ALC:BANDwidth?|:BWIDth?
Sets and queries the ALC bandwidth. This is actually not
continuously variable, so the input is rounded to the nearest possible
switch position. *RST setting is automatically determined since
is ON.
l
l POWer:ALC:BANDwidth|:BWIDth:AUTO?
Sets and queries the automatic ALC bandwidth selection switch. The
value is ON.
l POWer:ALC:CFACtor
l POWer:ALC:CFACtor?
Sets and queries the coupling factor used when the command
POWer : ALC is set to or
l
l POWer:ALC:SOURce?
Sets and queries the ALC leveling source selection switch.
The *RST value is
l
l POWer : ALC : ?
Sets and queries the state switch of the ALC. The positions are :
ON-normal ALC operation
OFF-open loop ALC mode
When on, the power can be programmed in fundamental units as
selected by the UNIT:POWer command.
When off, the power is no longer calibrated in absolute units and is
set in units of of arbitrary modulator setting.
l POWer:AMPLifier:STATE
l POWer : ier : STATE?
Sets and queries the state of the amplifier contained in
the doubler (for those models with a doubler installed).
Operating and Programming Reference HP 8360
User’s Handbook