HP 8360 - Manual (Page 348)

l suffix]
l
Sets and queries the amount of time in seconds that the synthesizer
stays (dwell) at each step after reporting a source settled
and
pulsing the Trigger Out line low. This one value is used at each step
when in the SWE:TRIG:SOUR IMM modeofa stepped sweep. Setting
SWEep:DWELL
OFF. *RST 100
l
l
Sets and queries the state of the automatic dwell calculation switch.
Setting SWEep:DWELL sets
OFF. *RST state is OFF.
Combining the Sweep Mode With the Sweep Generation Command
to Obtain the Desired Sweep Condition
Description of
Sweep Condition
CW Non-swept
Analog freq sweep
Manual analog sweep
Stepped freq sweep
Manual step freq sweep
CW with analog power
sweep
CW with manual analog
power sweep
CW with stepped power
sweep
CW with manual stepped
power sweep
Analog frequency and
power sweep
Manual analog frequency
and power sweep
Stepped frequency and
power sweep
Manual stepped frequency
and power sweep
List sweep
Manual list sweep
FREQ : P O W
c w FIX
S W E FIX
S W E FIX
S W E FIX
S W E FIX
c w S W E
c w S W E
c w S W E
c w S W E
S W E S W E
S W E S W E
S W E S W E
S W E S W E
LIST ignored
LIST ignored
S W E
ignored ignored
AUTO ignored
M A N ignored
AUTO ignored
MAN ignored
AUTO ignored
MAN ignored
AUTO ignored
MAN ignored
AUTO ignored
MAN ignored
AUTO ignored
MAN ignored
ignored AUTO
ignored MAN
S W E
:GEN
ignored
ANAL
ANAL
STEP
STEP
ANAL
ANAL
STEP
STEP
ANAL
ANAL
STEP
STEP
ignored
ignored
l SWEep:GENeration
l SWEep:GENeration?
Sets and queries the type of sweep to be generated: an analog sweep
or a digitally stepped sweep. In either case, all of the other sweep
subsystem functions apply. *RST is
Operating and Programming Reference HP 8360
User’s Handbook