HP 8360 - Manual (Page 368)

S t e p S w p P t
Trig Auto
Function Group
Menu Map
Description
Programming Codes
See Also
S w p
Trig
Function Group
Menu Map
Description
Programming Codes
See Also
FREQUENCY
2
When this is selected, the synthesizer automatically steps to
the next point in the stepped frequency sweep until all points are
swept. The time between points is equal to the sum of the dwell and
phase lock times. An asterisk next to the key label indicates that this
feature is active.
SCPI: SWEep:TRIGger:SOURce
Analyzer: NONE
Step Swp Menu, Sweep Mode Step
“Using Step Sweep,” in Chapter 1.
FREQUENCY
2
When this is selected, the synthesizer steps to the next point
in a stepped frequency sweep when an HP-IB trigger
(*TRG, <GET>) is received (leading edge TTL). When the last
frequency point is reached and continuous sweep is selected, the
next trigger causes the step sweep to return to the start frequency.
Connect the trigger signal to the TRIGGER INPUT BNC. An
asterisk next to the key label indicates this feature is active.
SCPI: SWEep:TRIGger:SOURce BUS
Analyzer: TS
Step Swp Sweep Mode Step
Operating and Programming Reference HP 8360
User’s Handbook