HP 8360 - Manual (Page 346)

command to set the switch will cause ROSC:SOUR:AUTO OFF to
be done also. The *RST value is automatically determined.
l ROSCillator:SOURce:AUTO
ROSCillator:SOURce:AUTO?
Sets and queries the automatic reference selection switch.
The *RST value is 1.
l STATus:OPERation:CONDition?
Queries the Standard Operation Condition register.
l STATus:OPERation:ENABle
l STATus:OPERation:ENABle?
Sets and queries the Standard Operation Enable register.
The value is 0.
l
Queries the Standard Operation Event Register. This is a destructive
read.
l STATus:OPERation:NTRansition
l STATus:OPERation:NTRansition?
Sets and queries the Standard Operation Negative Transition Filter.
The value is 0.
l STATus:OPERation:PTRansition
l STATus:OPERation:PTRansition?
Sets and queries the Standard Operation Positive Transition Filter.
After all used bits are set, to
l STATUS:PRESet
This command presets the following enable and transition registers:
MSIB,
and
Is set to all
Is set to all
All bits used are set to Unused bits remain
l STATus:QUEStionable:CONDition?
Queries the Data Questionable Condition Register.
l STATus:QUEStionable:ENABle
l STATus:QUEStionable:ENABle?
Sets and queries the Data Questionable SRQ Enable register.
The
value is 0.
Operating and Programming Reference HP 8360
User’s Handbook