HP 8360 User Manual
Page 341
Programming a specific value for POWer :
ier : STATE sets
POWer:AMPLifier:STATE:AUTOto OFF.
l
POWer:AMPLifier:STATE:AUTO
l
POWer:AMPLifier:STATE:AUTO?
Sets and queries the automatic selection of the doubler amplifier
state. Programming a specific value for POWer :
ier : STATE sets
POWer:AMPLifier:STATE:AUTO to OFF.
is ON.
l
POWer:ATTenuation
l
POWer :
ion?
Sets and queries the output attenuation level. Note that when
setting the attenuator level to 10
the output power is
decreased by 10
Programming a specified attenuation sets
POWer:ATTenuation:AUTO OFF.
l
POWer:ATTenuation:AUTO
l
POWer:ATTenuation:AUTO?
Sets and queries the state of the RF attenuator coupling switch.
Programming a specified attenuation sets
POWer :
ion : AUTO OFF.
ON insures that the amplitude level of the ALC is kept within
optimal limits.
OFF the attenuator setting is set to the value of POW :ATT and left
there. The
value is ON.
l
POWer:CENTer
suffix]
l
POWer:CENTer?
Sets and queries the center power for power sweep. Default units
(and units for query response) are determined by the UNIT:POWer
command.
The coupling equations for power sweep are exactly analogous to
those for frequency sweep. Power sweep is allowed to be negative,
unlike frequency sweeps. See FREQ : CENT for a description. *RST
value is 0
l
suffix]
l
POWer :
?
Sets and queries the output level. Default units and units
for the query response are determined by the UNIT:POWer
command. Maximum and minimum levels refer to the
leveling mode at the time the command is sent. For example,
:
MIN; ALC :
has different effects
from *RST;POWer:ALC:SOURceMMHead; POWer:LEVel MIN
After
the value is 0
l
POWer:MODE
l
POWer:MODE?
Sets and queries the setting of the power sweep mode switch. If in
HP 8360
User’s Handbook
Operating and Programming Reference