HP 8360 - Manual (Page 344)

COMMAND SUMMARY
analogous to those for frequency sweep. Power sweep is allowed to be
negative, unlike frequency sweeps.
value is 0
l PULM:EXTernal:DELay suffix]
l PULM:EXTernal:DELay?
Sets and queries the value of pulse delay from the time the external
pulse signal arrives to when the video pulse is generated. The
minimum value is
225 ns. After *RST the value is
l
l PULM:EXTernal:POLarity?
Selects the polarity of the external pulse signal. causes
the positive-going edge of the trigger the internal pulse
generator and to turn on the RF. After *RST the value is
l PULM:INTernal:FREQuency
l PULM:INTernal:FREQuency?
and queries the frequency of the internal pulse generator.
The *RST value is 500
l PULM:INTernal:GATE
l PULM:INTernal:GATE?
Sets and queries the state of the internal pulse generator’s gating
control. When ON, and the pulse trigger source is internal, the
external pulse input is used to gate the pulse generator. When pulse
trigger source is external, this switch is ignored and no gating is
possible. After
the setting is 0.
l PULM:INTernal:PERiod suffix]
l PULM:INTernal:PERiod?
Sets and queries the period of the internal pulse generator.
The *RST value is 2
l PULM:INTernal:TRIGger:SOURce
l PULM:INTernal:TRIGger:SOURce?
Sets and queries the setting of the internal pulse generator’s trigger
source. When
pulse period and frequency determine the
repetition rate of the pulse train. When in the repetition
rate is set by the EXT PULSE in jack. After the value is
l PULM:INTernal:WIDTH
l PULM:INTernal:WIDTH?
Sets and queries the width of the internal pulse generator. The *RST
value is 1
Operating and Programming Reference
HP 8360
User’s Handbook