Power sweep – HP 8360 User Manual
Page 281
Power Sweep
in
and t is either “DB” or the ASCII LF terminator. For
example, for a slope of 1.5 dB/GHz use this procedure:
1. 1.5 dB/GHz = 1.5
Hz
2. 1.5
Hz =
3. The programming code is
DB”
LEVEL
),
Power Sweep
“Power Sweep and Power Slope Operation” in Chapter 1.
Power Sweep
Function Group
Menu Map
Description
Programming Codes
See Also
POWER
This
enables the power sweep function. RF output power
can be swept both positively and negatively over a selected range.
The level of the power sweep starting point is the power level
programmed. Power sweep widths can be 45
wide in either
direction. However, the
power sweep range is dependent on
the ALC level set. An asterisk next to the key label indicates that
this feature is active.
POWer:MODE
POWer:STARt
POWer:SPAN <num>[level
Analyzer:
function on, PSO function off.
POWER LEVEL ,
“Power Sweep and Power Slope Operation” in Chapter 1.
HP 8360
User’s Handbook
Operating and Programming Reference