HP 8360 - Manual (Page 326)

l
Causes the sweep in progress to abort and reset. If CONT is
ON it immediately restarts the sweep. The pending operation flag
(driving and *OPC?) undergoes a transition once the
sweep is reset.
l
l
AM[:DEPThl?
Sets and queries the percentage of AM when the is
If <num> is received with units of the value is
converted to percent by the equation:
= 100 (1
Valid ranges of are 0 to 40 After the value is 50%.
l
l
AM:INTernal:FREQuency?
Sets and queries the frequency (in Hz) of the internal AM source.
After
the value is 1
l AM:INTernal:FUNCtion
l
AM:INTernal:FUNCtion?
Sets and queries the waveform of the internal AM source. After
the value is
l AM:SOURce
l AM:SOURce?
Sets and queries the source of the AM modulating signal. After
the value is
l AM:MODE
AM:MODE?
Controls the AM depth limits of the synthesizer. The
position is selected at
l AM:STATe
l AM:STATe?
Sets and queries the status of the AM modulation. After the
setting is OFF.
l AM:TYPE
AM:TYPE?
Sets and queries the type of AM modulation. After the
setting is
l CALibration:AM:AUTO
CALibration:AM:AUTO?
Sets and queries the automatic modulator calibration switch.
Operating and Programming Reference HP 8360
User’s Handbook