13 i/o voltage select signals, 14 test interface signals, 1 ieee 1149.1a-1993 interface description – IBM POWERPC 750GL User Manual
Page 275: 2 lssd_mode, Table 7-7, Bus voltage selection settings, Table 7-8, Ieee interface pin descriptions
User’s Manual
IBM PowerPC 750GX and 750GL RISC Microprocessor
gx_07.fm.(1.2)
March 27, 2006
Signal Descriptions
Page 275 of 377
7.2.13 I/O Voltage Select Signals
Table 7-7 shows the settings for the I/O voltage signals.
7.2.14 Test Interface Signals
The processor provides two sets of pins for controlling JTAG and level-sensitive scan design (LSSD) testing.
7.2.14.1 IEEE 1149.1a-1993 Interface Description
The 750GX has five dedicated JTAG signals, which are described in Table 7-8. The test data input (TDI) and
test data output (TDO) scan ports are used to scan instructions, as well as data into the various scan regis-
ters for JTAG operations. The scan operation is controlled by the test access port (TAP) controller, which in
turn is controlled by the test mode select (TMS) input sequence. The scan data is latched in at the rising edge
of the test clock (TCK). Test reset (TRST) is a JTAG optional signal, which is used to reset the TAP controller
asynchronously. The TRST signal assures that the JTAG logic does not interfere with the normal operation of
the chip, and must be asserted and deasserted coincident with the assertion of the HRESET signal.
7.2.14.2 LSSD_MODE
Table 7-7. Bus Voltage Selection Settings
Voltage Selection
OV
DD
Select #1
BVSEL
OV
DD
Select #2
L1TSTCLK
Reserved
0
0
1.8 V
0
1
2.5 V
1
1
3.3 V
1
0
Table 7-8. IEEE Interface Pin Descriptions
Signal Name
Input/Output
Weak Pullup Provided
IEEE 1149.1a-1993 Function
Timing Comments
TDI
Input
Yes
Serial scan input signal
Asserted/Negated—Not used
during normal operation. TMS,
TDI, and TRST have internal
pullups provided; TCK does not.
For normal operation, TMS and
TDI may be left unconnected,
TCK must be set high or low,
and TRST must be asserted
sometime during power-up for
JTAG logic initialization.
TDO
Output
No
Serial scan output signal
TMS
Input
Yes
TAP controller mode signal
TCK
Input
No
Scan clock
TRST
Input
Yes
TAP controller reset
State
Asserted
LSSD test enable. The LSSD test enable signal is an input-only signal.
Timing
Assertion/
Negation
Must be set high by the system during normal operation.