Siemens Simatic S7-400 - Manual (Page 331)

Analog Modules
5-115
S7-400, M7-400 Programmable Controllers Module Specifications
A5E00069467-07
Table 5-64 Parameters of the SM 431; AI 16 16 Bit, continued
Parameter Scope Parameter
Type
Default 2) Value Range
Measurement
•
Measuring type Disabled
U
Voltage
4DMU Current
(4-wire transmitter)
2DMU Current
(two-wire transmitter)
R-4L Resistor
(four-conductor terminal)
R-3L Resistor
(three-conductor terminal)
RTD-4L Thermal resistor
(linear, four-conductor
terminal)
RTD-3L Thermal resistor
(linear, three-conductor
terminal)
TC-L Thermocouple (linear)
U
Static Channel
•
Measuring range Refer to Section 5.22.2 for the
measuring ranges of the input
channels that you can set. " 10 V
•
teference
Temperature – 273.15 to 327.67 o C 0.00 o C
•
Interference
suppression 400 Hz; 60 Hz; 50 Hz 50 Hz
•
Smoothing None
Low
Average
High None
Dynamic Module
•
Ref. junction None
RTD on Channel 0
Reference temperature value None
1) If you use the module in ER-1/ER-2, you must set this parameter to “No” because the interrupt lines are
not available in ER-1/ER-2.
2) Only in the CC (central controller) is it possible to start up the analog modules with the default settings.
A Point to Note About Channels for Hardware Interrupts with the End of Scan
Cycle Trigger
You can parameterize hardware interrupts for the end of scan cycle for one of the
16 channels because the module can only trigger these interrupts on one channel.