Sub-Zero Sealed Burner RangeTop - Manual (Page 16)

16
C H A R B R O I L E R A S S E M B LY
Follow these steps to disassemble the
charbroiler for cleaning:
1) Remove the charbroiler grate. Refer to the
illustration below.
2) Remove the radiant plate. Refer to the
illustration below.
3) Remove the charbroiler frame.
4) After cleaning, put the charbroiler frame
back in place.
5) Line up the slots in the front of the radiant
plate with the front angle. The slots should
fit over the front angle and sit flat on the
charbroiler frame.
6) Reinstall the charbroiler grate.
W O L F S E A L E D B U R N E R R A N G E T O P
O P E R AT I O N
Be careful when assembling the compo-
nents. Avoid any contact with the igniter;
it is fragile and can chip or break.
Radiant
Plate
Front
Angle
Charbroiler radiant plate
Charbroiler
Grate
Charbroiler grate
I N F R A R E D
C H A R B R O I L E R
C H A R B R O I L E R O P E R A T I O N
IMPORTANT NOTE: The stainless steel cover
must be removed prior to operation of the
charbroiler.
Turn the knob counterclockwise to .
Preheat charbroiler for about 10 minutes
before adding the food. The ceramic tiles
will have an orange-red glow.
To turn the charbroiler off, turn the control
knob clockwise to the
position.
Do not use cookware on the charbroiler
grate.