GE Industrial Solutions AF-300 C11 - Manual (Page 33)

-31-
4-2 Operating Keypad Panel
1) Switching monitor
The display can be switched between frequency display and output current display by pressing
the in Operation mode.
2) Stopping operation
Operation is started when the RUN is pressed, and is stopped when the STOP is
pressed while function F 0 2 is set to 0 , 1 ,or 3 .
The rotation direction is:
Forward rotation with FWD-CM ON, and reverse rotation with REV–CM ON
3) Changing frequency
The frequency increases when the is pressed and decreases when the
is
pressed while function F 0 1 is set to 0 .
The change speed is increased when the is pressed at the same time as the
or .
Note: Do not turn the power off for five seconds after monitor switching or function setting,
to prevent Er1 occurrence.
*1 Frequency is displayed as a percentage with the
least significant digit in PID control operation
(function H20 is set to 1 or 2):
1 0. 0. for 10%
1 0 0. for 100%
*2 The reference frequency is displayed when the
key is pressed in current indication.
Current *2
Frequency *1
6 0. 0
1. 2 A
FUNC
DATA
FUNC
DATA
FUNC
DATA
FUNC
DATA
FUNC
DATA
FUNC
DATA