GE Industrial Solutions AF-300 C11 - Manual (Page 44)

Change during operation: N = impossible, Y* = possible (enabled by using ), Y= possible (enabled by using )
-42-
FUNC
DATA
Base frequency
This function sets a base frequency (branch point between constant torque characteristic and constant
output characteristic).
2 5
to The base frequency can be set with a resolution of 1 Hz in a range between
1 2 0 25 and 120 Hz.
Set a frequency matching the motor characteristics.
A value exceeding the maximum frequency can be set but the output voltage is reduced.
Data cannot be changed.
Acceleration time
0. 0
to
6 0. 0
0.01 is set when 0.0 is specified.
Deceleration time
0. 1
to
6 0. 0
F08
F07
The time taken to increase from 0.0 Hz to the maximum output frequency can be
set in an increment of 0.1 s step in a range between 0.0 and 60.0 s.
F05
F06
The time taken to increase from the maximum output frequency to 0.0 Hz can be set
in a range between 0.1 and 60.0 s. (In an increment of 0.1 s step)
F04
Maximum voltage
f Base frequency
V
Factory
setting
Change during
operation
60Hz N
Factory
setting
Change during
operation
0 N
Factory
setting
Change during
operation
6.0 Y
Factory
setting
Change during
operation
6.0 Y