Caution – GE Industrial Solutions AF-300 C11 User Manual
Page 5
-3-
Compliance with low voltage directive in EU [Continued]
!
CAUTION
Use of wires specified in Appendix C of EN 60204 is recommended.
*1
The applicable frame and series of the molded case circuit breaker (MCCB) and earth
leakage circuit breaker (ELCB) vary according to the capacity of the transformer of the
equipment. For details of selection, refer to the concerning technical documents.
*2
The recommended wire size for the main circuit is the case for the low voltage directive at
ambient temperature 40 °C.
*3
The power supply impedance without a reactor is considered to be the equivalent of 0.1%
of the drive capacity, with 10% current imbalance accompanied by the voltage imbalance.
*4
Crimp terminals up to 0.29” (7.4 mm) in width (including tolerance) can be used.
*5
Crimp terminals up to 0.37” (9.5 mm) in width (including tolerance) can be used.
*6
Use the grounding cable of a size equal to or larger than that of the input power supply
cable.
Recommended wire size AWG (mm
2
)
Molded case circuit
breaker (MCCB) or
earth leakage cir-
cuit breaker (ELCB)
Rated current [A]
Input circuit
*2
3-phase 200V
[L1/R, L2/S, L3/T],
single phase 200V
[L1/L, L2/N]
Power
supply
volt-
age
Nominal
applied
motor
[HP]
Drive type
With
DCR
Without
reactor
*
3
With
DCR
Without
reactor
*3
Output
circuit
*2
[U. V. W]
DCR
*2
circuit
[P1]
[P(+)]
Control
wiring
1/8
6KC1123F12X1**
1/4
6KC1123F25X1**
1/2
6KC1123F50X1**
5
1
6KC1123001X1**
5
10
2
6KC1123002X1**
15
3
6KC1123003X1**
10
20
14
(2.5)
*4
14
(2.5)
*4
14
(2.5)
*4
14
(2.5)
*4
3
-phase 230V
5
6KC1123005X1**
20
30
12
(4.0)
*5
10
(6.0)
*5
12
(4.0)
*5
12
(4.0)
*5
1/8
6KC1121F12X1**
1/4
6KC1121F25X1**
5
1/2
6KC1121F50X1**
5
10
1
6KC1121001X1**
10
15
14
(2.5)*
4
2
6KC1121002X1**
15
20
14
(2.5)
*4
(4.0)
*4
14
(2.5)*
4
14
(2.5)*
4
Single phase 230V
3
6KC1121003X1**
20
30
12
(4.0)
*5
10
(6.0)
*5
14
(2.5)
*5
12
(4.0)
*5
20
(0.5)