GE Industrial Solutions AF-300 C11 - Manual (Page 79)

- 77 -
IN-WARRANTY FAILURE CHECKLIST
To assist with warranty troubleshooting, the following information is required. This data is needed to evaluate the
cause in an effort to eliminate any further failures.
Model No.:_____________________________________________________________
Serial No.:____________________________________________________________
Start-Up Date:_________________________________________________________
Failure Date:__________________________________________________________
Status When Failure Occurred (check one):
Power-Up___________ Running____________ Accel__________ Decel__________
Explanation of Failure ________________________________________________
Application Information (check Yes or No)
Input Transformer: Yes______ No______
If Yes: KVA____________________________
L1 Volts______ L2 Volts______ L3 Volts______
Power Factor Correction Capacitors: Yes______ No______
If Yes: Microfarrad_______________
Other Equipment on Same Power Yes______ No______
If Yes, what?
Line Reactor on Input Yes______ No______
Input Starter Yes______ No______
Output Starter Yes______ No______
Motor Overloads Yes______ No______
Control Terminals Used (circle if used)
30A 30B 30C FM X1 X2 X3 FWD REV CM 11 12 13 C1
Function Codes Different From Factory Settings
Failure Message (see Section 4)
Latest Fault_____________ Previous Faults: No Message_________
Hz_________________ 1._______________
A__________________ 2._______________
V__________________ 3._______________
After all of the Checklist information is acquired, contact the following number for assistance: (540) 387-5739
When returning failed parts, reference the C----# on the shipping documents that came with the replacement parts
and ship failed parts to: GE Fuji Drives USA, Inc. · Attn: Product Service Dept. · Rm 191 · 1501 Roanoke Boule-
vard · Salem. VA 24153
(Marked C----#)
Function Code Setting Function Code Setting