Agilent Technologies Option H48 Multiport Test Set Z5623A - Manual (Page 30)

2 -14 Agilent Technologies Z5623A Option H48
Installation
Connecting and Turning on the Test Set
NOTE The test set is shipped from the factory with the GPIB address set to 12.
Connecting and Turning on the Test Set
Make the connections shown in Figure 2-9, “Detailed Equipment
Connection Diagram.” The figure shows two RF cables connecting the
network analyzer to the test set. If you intend to verify the performance
of the test set, use the long RF cables listed in
Table 2-3 . Otherwise, use
the short ones.
Plug power cords into the test set. Turn both instruments on.
NOTE Allow the test set to warm up for at least 2 hours. For the most stable
and accurate measurements, leave the test set turned on at all times.
Table 2-3 RF Cables Connecting Network Analyzer to Test Set
Length Part No. Purpose
Long 8120-4781 Verification of test set performance
Short 8120-4782 Measurement of multiport devices